濟南飼料機械廠
聯系人：安經理
手機：152-5313-4653
郵箱：347299818@qq.com
地址：濟南市濟北開發區
自動喂料機專門解決養雞廠工人勞動強度大，針對中、小型雞場設施布局不規范研制設計的，其結構獨特、新穎實用、省時省力、喂料均勻、損耗少，有效的提高了工作效率，無論其結構還是性能方面都是首創，是養雞廠理想的換代設備。那么應該如何保養呢？
一、因為喂料機的各種機件之間都是有齒輪和鏈條控制連接的，所以必須使齒輪和鏈條保證最大的潤滑度，這樣才不會因為缺乏潤滑而損壞機器。
Because among the various parts feeders are connected to a gear and chain control, it is necessary to make gears and chains to ensure maximum lubrication, so as not to damage the machine because of a lack of lubrication.
二、喂料機在開動的時候，上面最好不要放東西，那樣的話容易導致電機承受的壓力過大而燒壞電機。
Feeder at the start, when the top is best not to put things, so if the pressure likely to cause the motor to burn out the motor too large.
三、檢查皮帶是否完好，是否有松動。喂料機的是靠皮帶來傳輸物料的，只有皮帶正常才能充分的發揮機器的生產性能，作業量才能達到最大。
Check the belt is intact, if there is loose. Feeder is transmitted by skin to bring the material, only the belt to fully play the normal performance of the machine, in order to achieve the maximum amount of work.
四、由于飼料的生產時會產生很大的灰塵，會使得喂料機的控制箱內積累大量的灰塵，灰塵會使內部電路發生短路，損毀電器電路和其它部件，所以每隔一段時間要清理一下控制箱中的灰塵。
Because a lot of dust generated during feed production, will make the control of the feeder box accumulate a lot of dust, dust causes an internal short circuit occurs, damaged electrical circuits and other components, so every once in a while to clean up control dust box.